In these times where we have great innovations in networking technology, it is quite difficult to imagine those days when people were dependent on power network cables and electrical wiring. This was not possible due to a lack of technical network cable knowledge and equipment. But thanks to great inventions and innovations, we now live in a world where we don’t need anyone else but ourselves to provide electricity and even more so internet connectivity. In fact, it is almost impossible to find any home without at least 1 network cable and many homes have several of them. We should always keep our minds open to making use of the latest technological advancements. We may also want to read further about “How to Install cat6 plenum 1000 ft Ethernet Networking Cables”
Ethernet Guide
It seems simple enough today, but if you think back to how difficult it was years ago, then you might just realize how much time and money we could save by following this guide. Just as I am sure that the old timers would tell us, it is best to follow the guide step by step. You may need to take down some of the wall hangings and perhaps remove some parts of the ceiling, but you will end up saving a lot of time and effort. So let’s first start out with the basics.
Before you begin, make sure that you understand what plenum space is. Plenum space is often referred to as the space above a raised floor in commercial buildings, and it is generally an empty space between floor joists or rafters. If you work in a high-rise building, you might have seen the term plenum space used frequently. In order to know whether you have a plenum area in your home, first, look around. Are there exposed beams, pipes, ductwork, or wires hanging down? If yes, then it means that you do indeed have a plenum area.
Ethernet Devices
If you have access to a router, simply plug it into an ethernet port that is located near the middle of the room. Once you do this, you will probably discover that the lights go off and the computer screen goes blank. However, once you plug the Ethernet cable directly into the modem instead of the router, the lights won’t turn off and the computer will remain functional. As long as you remember to do this whenever you move to a different location, you can always connect to the Internet again.
After you have done the basic main setup, it is time to start installing the networking cables. First, decide on the type of connectors you’ll be using. Most likely, you’ll be using RJ45 connectors which are known as UTP (Unshielded Twisted Pair). The good thing about these connectors is that they are flexible and offer excellent flexibility in routing the cables. Now that the decision has been made, it is time to get started. You will need to identify the cable’s length before you go ahead and cut it. It is important to note that you should never cut the.
